Resource Type

Journal Article 344

Conference Videos 2

Year

2023 7

2022 14

2021 21

2020 13

2019 16

2018 16

2017 15

2016 14

2015 17

2014 10

2013 12

2012 15

2011 15

2010 29

2009 28

2008 31

2007 31

2006 7

2005 3

2004 2

open ︾

Keywords

coefficient 13

pressure 11

pressure drop 7

different 6

High pressure 5

numerical simulation 5

CFD 4

friction coefficient 4

heat transfer coefficient 3

permeability 3

simulation 3

temperature 3

Block cipher 2

CO2 capture 2

DX pile 2

Diamond anvil cell 2

Particle Swarm Optimization (PSO) 2

development 2

effective diffusion coefficient 2

open ︾

Search scope:

排序： Display mode:

Experimental study of wind loads on gable roofs of low-rise buildings with overhangs

Peng HUANG, Ling TAO, Ming GU, Yong QUAN

Frontiers of Structural and Civil Engineering 2018, Volume 12, Issue 3,   Pages 300-317 doi: 10.1007/s11709-018-0449-7

Abstract: The wind pressure distributions on gable roofs of low-rise buildings are investigated by a series ofThe block pressure coefficients and worst negative (block) pressure coefficients on different roof regionsThe effects of roof pitch, height-depth ratio, and width-depth ratio on the pressure coefficients ofIn addition, the pressure coefficients on the roofs for the main structure and building envelope areLastly, the block pressure coefficients and worst negative pressure coefficients are recommended to guide

Keywords： low-rise building     gable roof     wind loads     wind tunnel test     block pressure coefficient     load code    

HTML PDF Collect

Wind tunnel test study on the wind pressure coefficient of claddings of high-rise buildings

Yong QUAN, Yi LIANG, Fei WANG, Ming GU

Frontiers of Structural and Civil Engineering 2011, Volume 5, Issue 4,   Pages 518-524 doi: 10.1007/s11709-011-0128-4

Abstract: The area-averaged most unfavorable wind pressure coefficients (MUWPCs) on various regions of building

Keywords： side ratio     area-averaged pressure coefficients     cladding     terrain category    

HTML PDF Collect

Interfacial heat transfer coefficient between metal and die during high pressure die casting process

GUO Zhipeng, XIONG Shoumei, CHO SangHyun, CHOI JeongKil

Frontiers of Mechanical Engineering 2007, Volume 2, Issue 3,   Pages 283-287 doi: 10.1007/s11465-007-0049-z

Abstract: The present work focused on the determination of the interfacial heat transfer coefficient (IHTC) betweenmetal and die during the high pressure die casting (HPDC) process.

Keywords： so-called     calculation     inverse     interfacial     aluminum    

HTML PDF Collect

Design new ideas and engineering practice of high-pressure water-rich fault “outside block and inside

Zhang Minqing,Zhang Mei

Strategic Study of CAE 2009, Volume 11, Issue 12,   Pages 26-34

Abstract: It is rich in high-pressure water, with the biggest single whole water inflow of 1 800 m3/h and waterpressure of 2.5 MPa.The common design for high-pressure water-rich fault is thicker reinforced ring and stronger reinforcedWhile "outside block and inside solid grouting"  assumes the distribution of surroundingThe grouting holes and grouting quantity of "outside block and inside solid grouting"  

Keywords： high-pressure water-rich fault     unevenness     blocking water and strengthen by grouting     outside block    

HTML PDF Collect

Coulomb-type solutions for passive earth pressure with steady seepage

WANG Junjie, CHAI Hejun, LIN Xin, XU Jiamei

Frontiers of Structural and Civil Engineering 2008, Volume 2, Issue 1,   Pages 56-66 doi: 10.1007/s11709-008-0001-2

Abstract: Present paper deals with the computing of passive earth pressure acting on the vertical rigid retainingon the general solutions, the variations of the critical inclination of the failure surface and the coefficientof passive earth pressure with increasing the effective friction angle of the soil mass, the soil/structureTwo tables with values of the coefficients of passive earth pressure for Cases 1 and 3 respectively are

Keywords： function     coefficient     Coulomb-type     effective friction     different drainage    

HTML PDF Collect

Comparison and harmonization of building wind loading codes among the Asia-Pacific Economies

Yaojun GE, Shuyang CAO, Xinyang JIN

Frontiers of Structural and Civil Engineering 2013, Volume 7, Issue 4,   Pages 402-410 doi: 10.1007/s11709-013-0230-x

Abstract: loading model is given as a famous wind loading chain described by four variables including velocity pressure, exposure factor, pressure coefficient, and gust response factor.

Keywords： wind loading     codification     velocity pressure     exposure factor     pressure coefficient     gust response factor    

HTML PDF Collect

Transient analysis of thermoelastic contact problem of disk brakes

Ali BELHOCINE, Mostefa BOUCHETARA

Frontiers of Mechanical Engineering 2013, Volume 8, Issue 2,   Pages 150-159 doi: 10.1007/s11465-013-0266-6

Abstract: coupling to determine the deformation established and the Von Mises stresses in the disk, the contact pressure

Keywords： brake disks     heat flux     heat-transfer coefficient     Von Mises stress     contact pressure    

HTML PDF Collect

Laser ablation of block copolymers with hydrogen-bonded azobenzene derivatives

Jintang Huang, Youju Huang, Si Wu

Frontiers of Chemical Science and Engineering 2018, Volume 12, Issue 3,   Pages 450-456 doi: 10.1007/s11705-018-1735-6

Abstract: fabricated by hydrogen-bonding azobenzene derivatives (AzoR) to poly(4-vinyl pyridine) blocks of polystyrene-block-poly

Keywords： laser ablation     block copolymers     hydrogen-bond     azobenzene derivatives     supramolecular assembly    

HTML PDF Collect

Research of water distribution of tunnel lining in Karst region

Tan Zhongsheng,Li Jian,Xue Bin,Wan Xiuying

Strategic Study of CAE 2009, Volume 11, Issue 12,   Pages 87-92

Abstract: on different anti-drainage patterns (the whole block, block combined with drainage and drainage modeModel test scale was 1∶16, and test apparatus could be applied earth pressure and water pressure.Acquiring the distribution of linning water pressure by model test: the lining water pressure can't discounted and reduced by the grouting ring at the condition of whole block; the lining water pressurereduced significantly and linear decreased as the development of drainage discharge at the condition of block

Keywords： tunnel in Karst region     whole block     controlled drainage     water pressure     model test    

HTML PDF Collect

Ductility improvement of GFRP-RC beams using precast confined concrete block in compression zone

Frontiers of Structural and Civil Engineering doi: 10.1007/s11709-023-0968-8

Abstract: ductility of their compression zones, the present study proposes using a precast confined concrete block

Keywords： ductility     four-point bending test     glass fiber-reinforced polymer     precast confined concrete block    

HTML PDF Collect

Preparation of polysulfone-based block copolymer ultrafiltration membranes by selective swelling and

Frontiers of Chemical Science and Engineering 2022, Volume 16, Issue 5,   Pages 745-754 doi: 10.1007/s11705-021-2038-x

Abstract: Selective swelling of block copolymers of polysulfone-b-poly(ethylene glycol) is an emerging strategySelective swelling was performed on the obtained block copolymer structures in the solvent pair of ethanolhydrochloric acid and the spaces initially occupied by CaCO3 provided extra pores to the block

Keywords： block copolymers     selective swelling     ultrafiltration     CaCO3 nanoparticles     sacrificial nanofillers    

HTML PDF Collect

Thermoresponsive block copolymer supported Pt nanocatalysts for base-free aerobic oxidation of 5-hydroxymethyl

Frontiers of Chemical Science and Engineering 2021, Volume 15, Issue 6,   Pages 1514-1523 doi: 10.1007/s11705-021-2092-4

Abstract: a thermoresponsive poly(acrylamide-co-acrylonitrile)-b-poly(N-vinylimidazole) blockThe imidazole groups in the block copolymer were conducive to the improvement of catalytic performance

Keywords： aerobic oxidation     base-free     5-hydroxymethyl-2-furfural     Pt nanoparticle     thermoresponsive block copolymer    

HTML PDF Collect

Molecular dynamics study of water diffusion in an amphiphilic block copolymer with large difference in

Yang Zhou, Phillip Choi

Frontiers of Chemical Science and Engineering 2017, Volume 11, Issue 3,   Pages 440-447 doi: 10.1007/s11705-017-1626-2

Abstract: The computed self-diffusion coefficient of water increased exponentially with increasing water concentration

Keywords： molecular dynamics simulation     amphiphilic block copolymer     free volume     water diffusivity     fujita model    

HTML PDF Collect

RETRACTED ARTICLE: Momentum exchange coefficient for two jet flows mixing in a tee junction

Frontiers of Chemical Science and Engineering 2023, Volume 17, Issue 12,   Pages 2161-2161 doi: 10.1007/s11705-009-0143-3

Abstract: RETRACTED ARTICLE: Momentum exchange coefficient for two jet flows mixing in a tee junction

Keywords： tee junction     Momentum exchange coefficient     RETRACTED    

HTML PDF Collect

Wear mechanism of disc-brake block material for new type of drilling rig

WANG Xinhua, WANG Simin, ZHANG Siwei, WANG Deguo

Frontiers of Mechanical Engineering 2008, Volume 3, Issue 1,   Pages 10-16 doi: 10.1007/s11465-008-0009-2

Abstract: Topography and elementary components of the brake block’s wear surface are analyzed by employing SEMWhen the frictional temperature is lower, the surface film of the brake block is thinner, dense, smoothwear, the hard peaks from the friction surface of the disc-brake plough on the surface of the brake blockfriction heat, obvious softening and plastic flow can be found on the friction surface of the brake blockThermal decomposition of cohesive material in the brake block is simultaneously strengthened, so that

Keywords： asbestos-free frictional     Fracture     cyclization     friction     disc-brake    

HTML PDF Collect

Title Author Date Type Operation

Experimental study of wind loads on gable roofs of low-rise buildings with overhangs

Peng HUANG, Ling TAO, Ming GU, Yong QUAN

Journal Article

Wind tunnel test study on the wind pressure coefficient of claddings of high-rise buildings

Yong QUAN, Yi LIANG, Fei WANG, Ming GU

Journal Article

Interfacial heat transfer coefficient between metal and die during high pressure die casting process

GUO Zhipeng, XIONG Shoumei, CHO SangHyun, CHOI JeongKil

Journal Article

Design new ideas and engineering practice of high-pressure water-rich fault “outside block and inside

Zhang Minqing,Zhang Mei

Journal Article

Coulomb-type solutions for passive earth pressure with steady seepage

WANG Junjie, CHAI Hejun, LIN Xin, XU Jiamei

Journal Article

Comparison and harmonization of building wind loading codes among the Asia-Pacific Economies

Yaojun GE, Shuyang CAO, Xinyang JIN

Journal Article

Transient analysis of thermoelastic contact problem of disk brakes

Ali BELHOCINE, Mostefa BOUCHETARA

Journal Article

Laser ablation of block copolymers with hydrogen-bonded azobenzene derivatives

Jintang Huang, Youju Huang, Si Wu

Journal Article

Research of water distribution of tunnel lining in Karst region

Tan Zhongsheng,Li Jian,Xue Bin,Wan Xiuying

Journal Article

Ductility improvement of GFRP-RC beams using precast confined concrete block in compression zone

Journal Article

Preparation of polysulfone-based block copolymer ultrafiltration membranes by selective swelling and

Journal Article

Thermoresponsive block copolymer supported Pt nanocatalysts for base-free aerobic oxidation of 5-hydroxymethyl

Journal Article

Molecular dynamics study of water diffusion in an amphiphilic block copolymer with large difference in

Yang Zhou, Phillip Choi

Journal Article

RETRACTED ARTICLE: Momentum exchange coefficient for two jet flows mixing in a tee junction

Journal Article

Wear mechanism of disc-brake block material for new type of drilling rig

WANG Xinhua, WANG Simin, ZHANG Siwei, WANG Deguo

Journal Article